Products | Features | Producer | Contact             D | E | F   F E A T U R E S Contego combines functionality with a modern design. No more tripping over or spaghetti cables with the new cable conduit. Contego incorporates three bays for cable harnesses which can be laid professionally, compactly and with precision. Aluminium skirting & Plastic element with guide rails           The push & press skirting board with integrated cable ducts The centrepiece of Contego is a plastic element with guide rails for the cables. It is simply screwed to the wall and covered with a high quality skirting board of silvercoloured anodized aluminium. Practical detail: the cover of the connector system is snapped into the plastic element mounted on the wall. This unobtrusive mounting without any visible screws makes the aluminium skirting board look very sleek in modern-style rooms.           Integrated snap-in system   Compensating for sinking           Compensating for sinking When new floors sink the impression is given that the skirting boards were mounted too high. Contego resolves this problem with an integrated snap-in system which allows the aluminium cover to be adjusted to the wall-mounted plastic element. With a push and press movement the skirting board will be perfectly aligned to the level of the floor.         Assembly with rubber seal           Rubber lips for sealing Where necessary, a special rubber lip can be used to seal any gaps. It is inserted at the bottom of the aluminium skirting board. If the rubber seal is not needed the lower part of the plastic element is removed at the predetermined breaking point. The plastic element mounted on the wall will always be aligned at the correct height and, together with the aluminium cover, gives an even termination.           Assembly without rubber seal             Einfache Montage Wird die Gummidichtung nicht benötigt, entfernt man das untere Teil des Kunststoffelementes an der integrierten Sollbruchstelle. Das wandseitig montierte Kunststoffteil wir so auf alle Fälle immer in der richtigen Höhe montiert und weist mit der Alublende wieder die gleiche Höhe auf für einen gleichmässigen Abschluss.           Break section   for cable entry and exit points           Flexible cable entry and exit points Predetermined breaking points in the connecting pieces enable the cables to be inserted or extracted to round-off the impression of contemporary architecture. » Download Contego Flyer (PDF 700 KB)